PREORDER
Production lead time Approximately 2-3 months
Taking full payment in advance
RCN Studio Figures Power Unit
This set is designed for remote control your figure's lighting feature. Mainly for Ironmans but not limited to Ironmans
Use this set to link-up all battery cells on your figure to one control unit power by USB. So you don't need to move your posed figure or change batteries over time
This set contains:
1) Remote control
2) USB wire
3) Connection port
4) Black tapes
5) Tweezers
6) 11 power units including:
- 4 units for replacing AG1 battery
- 2 units for replacing AG3 battery
- 1 unit for replacing AG9 battery
- 4 units for replacing AG0 battery
Above power units should cover Hot Toys Ironman MK3/5/42/43/46/47/85
---------------------------------------------------------------------------------------------
Product description & Instruction <-- Click here
Assembling demo video <-- Click here
-----------------------------------------------------------------------------------------------------------------
The Power Distribution Supply Set is available in standard 3V to 4.5V.
Refer to the product guide for the components of the product set.
If you have a desired voltage, refer to the instruction link above.
1) Please leave a note about the desired voltage (adjustable within 5 volts)
2) You need to purchase an adapter separately from 5V or higher. Select the Add Product option. (You can replace it with an Atopter instead of a USB.)
More power units for different battery type and color LED stripes will be available by later stage
NOTES from RCN Studio:
If AG0 does not meet the specifications, you should use AG1.
We'll explain why below.
Q: My power supply is not the right size.
A. Actually, the AG0 is designed to be interchangeable with the AG1, depending on the state of the product.
This is because the specifications of mercury batteries are often misrepresented in Hot Toys' product guide manuals.
Most Hot Toy buyers don't realize this error because they insert mercury batteries into their Iron Man products without looking at the manual.
However, when you purchase a power unit, you are reading the hot toy manual and ordering the correct battery size.
Note that this is the cause of the error.
If possible, don't rely on the product manual, and make sure you have a rough estimate of the size of the mercury battery compartment on the actual product.
If your AG0 doesn't fit the specifications, press the spring as hard as you can from both sides and then insert it with special tweezers.
When inserting, it is important to press down on the power unit with the thumb of your left hand to make sure it is fully seated.
If the compartment is too wide for AG0 to fit, use AG1.
Q. Are the springs solderable?
A. No, the springs are not solderable - they are not solderable.
Q. If I use a power unit, will it damage the LEDs in the product?
A. With the power unit, there is no need to worry about overloading the LEDs.
This product has a resistor design in the body of the USB line. It is precisely adjusted from a minimum of 3.5V to a maximum of 4.5V.
We can also adjust this power consumption up to 24V upon customer request.
However, for hot toys, the current power is suitable.
Thank you.